Table of Contents
Advertisement
OPTIMOD 6300 DIGITAL
D) Turn the knob to set the desired permission level for the passcode you are ed-
iting.
E) Press the N
EXT
Your new permission level is stored and the Security menu appears.
To Delete a Passcode:
A) Navigate to S
If the front panel is already password protected, you can only access this
screen by entering a passcode with All Access privileges.
B) Turn the knob until you see the passcode you want to delete.
C) Press the N
EXT
D) Press the Y
buttons to abort deleting the passcode.
To Lock the Front Panel Immediately:
After you have adjusted the processor, to maximize security you will often want
to lock it immediately without waiting for the timeout. To do so:
A) Press the S
ETUP
B) Press the L
OCK
To Program local lockout:
A) Navigate to S
If the front panel is already password protected, you can only access this
screen by entering a passcode with A
B) Hold down the A
lockout time (if any).
You can program the lockout delay time (in hours:minutes) from 15 min-
utes to 8 hours, or O
local front panel control and when the front panel automatically locks it-
self out, requiring entering a passcode to obtain front panel control of
the 6300.
Autolock can only be turned on if at least one passcode exists with A
A
CCESS
unlock the panel or to turn off the Autolock function.
C) Press the E
SCAPE
To Unlock the Front Panel:
A) On the 6300 front panel, operate any button or the knob.
button to confirm your choice.
> S
> D
ETUP
ECURITY
button. The Confirm Delete screen appears.
soft button to delete the passcode. Press the NO or ESCAPE
ES
button.
N
soft button.
OW
> S
ETUP
ECURITY
.
UTOLOCK
soft button and turn the knob to set the desired
. This is the time delay between the last access to a
FF
privileges because an A
button to leave the Security menu.
P
.
ELETE
ASSCODES
A
privileges.
LL
CCESS
A
passcode is required to fully
LL
CCESS
2-43
INSTALLATION
LL
Advertisement
Table of Contents
Troubleshooting
