Quick Setup - Orban OPTIMOD 6300 Operating Manual

Digital multipurpose audio processor, version 2.3 software
Hide thumbs Also See for OPTIMOD 6300:
Table of Contents

Advertisement

2-12
INSTALLATION

Quick Setup

Quick Setup guides you through 6300 setup. It is appropriate for users without spe-
cial or esoteric requirements. It does not cover setting D
plications. Following this section, you can find more detailed information regarding
setup beyond the Quick Setup screens, including how to set up the 6300 to drive a
Dolby Digital channel. In most cases, you will not need this extra information.
Quick Setup assumes that your 6300 will be driving flat channels because this is the
most common scenario. If you need it, you can turn on pre-emphasis after you com-
plete Quick Setup. If you are setting up the 6300 to process for analog television
preemphasized at 50s or 75s, please refer to the complete setup instructions
found in Analog and Digital I/O Setup starting on page 2-20.
For the following adjustments, use the appropriately labeled soft button to choose
the parameter you wish to adjust. To change a parameter (like an output level), it is
usually necessary to hold down the soft button while turning the knob. However, if
there is only one parameter on a screen, you can change this with the knob alone.
(You do not have to hold down a button.) Let the text on the screen guide you
through the process.
1. Press the front-panel Setup button.
2. Press the Quick Setup soft button when its label appears on the display.
Quick Setup presents a guided sequence of screens into which you must insert in-
formation about your particular requirements. In general, the screens are self-
explanatory.
Use the N
and P
EXT
flash to indicate that they are active.
3. Set the time.
A) Press the N
EXT
button.
The set time screen appears.
B) Hold down the appropriate soft button while turning the knob to enter the
hour, minute, and seconds. Enter seconds slightly ahead of the correct time.
C) Wait until the entered time agrees with the correct time. Then press the
E
T
button to set the clock.
NTER
IME
4. Set the date.
Hold down the appropriate soft button while turning the knob to enter the day,
month, and year.
buttons to navigate between screens. These buttons will
REV
ORBAN MODEL 6300
in Dolby Digital ap-
IALNORM

Advertisement

Table of Contents
loading

Table of Contents