Orban OPTIMOD 6300 Operating Manual page 57

OPTIMOD 6300 DIGITAL
4. Connect inputs and outputs.
See the hookup and grounding information on the following pages.
TOPIC
Audio Input and Audio Output Connections.............................................2-5
AES3 Digital Input and Output ...................................................................2-7
Wordclock / AES11id Sync Input .................................................................2-7
Grounding ....................................................................................................2-7
PIN ASSIGNMENT
1. COMMON
2. REMOTE
3. REMOTE
4. REMOTE
5. REMOTE
6. REMOTE
7. REMOTE
8. REMOTE
9. REMOTE
10. TALLY
11. TALLY
12. N/C
13. POWER COMMON
14. REMOTE
15. REMOTE
16. REMOTE
17. REMOTE
18. REMOTE
19. REMOTE
20. REMOTE
21. REMOTE
22-24. N/C
25. +12 VOLTS DC
Figure 2-2: Wiring the 25-pin Remote Interface Connector
5. Connect remote control interface. (optional)
For a full listing of 6300's extensive remote control provisions, refer to Remote
Control Interface Programming on page 2-45.
Optically isolated remote control connections are terminated in a type DB-25
male connector located on the rear panel. It is wired according to Figure 2-2. To
select the desired function, apply a 5-12V AC or DC pulse between the appropri-
ate REMOTE INTERFACE terminals. The () terminals can be connected together
and then connected to ground at pin 1 to create a Remote Common. A current-
limited +12VDC source is available on pin 25. If you use 48V, connect a 2k
10%, 2-watt carbon composition resistor in series with the Remote Common or
the (+) terminal to provide current limiting.
1+
2+
3+
4+
5+
6+
7+
8+
1
2
1-
2-
3-
4-
5-
6-
7-
8-
PAGE
REMOTE INTERFACE
2-3
INSTALLATION