Orban OPTIMOD 6300 Operating Manual page 101

OPTIMOD 6300 DIGITAL
a) Use the N
IP address. Use the knob to set the digit to the desired value. Repeat until
you have selected all the numbers in the IP address assigned by your
network administrator
b) Press the S
C) Set the Subnet Mask assigned by your network administrator if necessary:
a) Press the S
N
b) Use the
subnet mask. Use the knob to set the digit to the desired value. Repeat
until you have selected all the numbers in the subnet mask assigned by
your network administrator
c) Press the S
D) Set the Gateway assigned by your network administrator if necessary:
a) Press the G
N
b) Use the
gateway. Use the knob to set the digit to the desired value. Repeat until
you have selected all the numbers in the gateway assigned by your
network administrator
c) Press the S
E) Set the IP Port assigned by your network administrator if necessary:
a) Press the IP P
N
b) Use the
port. Use the knob to set the digit to the desired value. Repeat until you
have selected all the numbers in the IP port assigned by your network
administrator
c) Press the S
F) Connect your Ethernet network to the RJ45 jack on the rear panel of your
6300.

If you are connecting to a hub or router, use a standard Ethernet cable.

If you are connecting directly to the Ethernet jack on a computer, use a
"crossover" or "reverse" Ethernet cable.
G) Press the N
EXT
2. Prepare the 6300 for modem connection through the serial port:
[Skip this step if you will not be using a modem connection.]
A) Navigate to S
B) Hold down the PC C
M
on the display.
ODEM
and P
EXT REV keys to move the cursor in turn to each digit in the
soft button to confirm your setting.
AVE
S
M
ET UBNET soft button.
ASK
P
and keys to move the cursor in turn to each digit in the
EXT REV
soft button to confirm your setting.
AVE
soft button.
ATEWAY
P
and keys to move the cursor in turn to each digit in the
EXT REV
AVE soft button to confirm your setting.
ORT soft button.
P
and keys to move the cursor in turn to each digit in the IP
EXT REV
soft button to confirm your setting.
AVE
button.
> N & R
ETUP ETWORK EMOTE
ONNECT soft button and turn the knob until you see
.
2-47
INSTALLATION