Orban OPTIMOD 6300 Operating Manual page 94

2-40
INSTALLATION
3. To add an automation event:
A) Push the A E
DD VENT
B) Choose whether you wish to program an event that occurs only once or an
event that follows a daily or weekly schedule.
C) For events that occur only once:
P
a) Use the
REV
and turn the knob so that is reads "
b) Use the P
REV
year when the automation event will occur. Set the desired values with the
knob.
c) Use the P
REV
and second (in 24-hour format) when the automation event is to occur. Set
the desired values with the knob.
D) For events that occur on a daily or weekly schedule:
a) Use the P
REV
week in turn, and use the rotary encoder to turn the day on or off.
You can program the event to occur on as many days of the week as you
wish.
b) Use the P
REV
and second (in 24-hour format—e.g., 18:00:00 for 6:00 PM) when the
automation event is to occur. Set the desired values with the knob.
Automation events have a "start" time but no "stop" time. The 6300 will
indefinitely remain in the state specified by an existing automation event
until its state is changed by another automation event or by another ac-
tion (such as a user's interacting with the front panel or PC Remote soft-
ware).
E) For all events:
S
a) Press the
ELECT
b) Turn the knob to set the desired event. The available events are:

Recall factory preset

Recall user preset

stereo mode

dual-mono
This mode processes the two input channels independently.

bypass mode

exit test (restores the operating preset that was active before a test
mode was invoked)
button.
N
and buttons to move the cursor over the word "
EXT
and N
buttons to move the cursor to the day, month, and
EXT
and N
buttons to move the cursor set the hour, minute,
EXT
and N
buttons to move the cursor the each day of the
EXT
and N
EXT buttons to move the cursor set the hour, minute,
E
button.
VENT
(DUALMONO)
mode
DATE:
" instead.
ORBAN MODEL 6300
DAILY:
"