Orban OPTIMOD 6300 Operating Manual page 237

OPTIMOD 6300 DIGITAL
d) Evenly tighten all eight screws to reattach the board assembly to the panel.
D) Place the two side brackets over the captive screws located on each side of the
front panel. Be sure that the large side of each bracket is oriented toward the
rack-screw cutouts in the panel.
E) Place the metal shield over the captive screws on each side of the front panel.
Align the shield so that its cutouts are aligned with the cables attached to the
circuit board assembly. Using a 3/16" nut driver, screw four hex nuts onto the
captive screws.
F) Attach the front panel assembly to the unit:
a) Verify that all cables are dressed through cutouts in the shield.
b) Slide the front panel assembly into the front of the chassis so that the three
threaded holes in the side brackets line up with the holes in the sides of the
chassis.
c) Attach the front panel assembly by screwing the six screws removed in step
2.B)a) on page 4-2 into the holes in the sides of the chassis.
G) Reattach the four cables that connect the display board to the base board.
Each cable has a different type or size of connector, so it is obvious which ca-
ble mates with which jack on the base board.
Carefully align the cables and connectors to avoid bending the pins.
9. Replacing the Top Cover:
Place the cover on the unit and reinstall the Phillips screws. (Be careful not to
pinch any cables.)
4-5
MAINTENANCE