Orban OPTIMOD 6300 Operating Manual page 71

OPTIMOD 6300 DIGITAL
 To use program material, press the N
16. Set the analog output level.
A) Press the N
EXT
B) [Skip this step if you are not using the analog output.]
Turn the knob to set the desired analog output level corresponding to
100% modulation, in units of dBu (0 dBu = 0.776 Vrms).
Refer to Setting Output/Modulation Levels on page 1-25.
If you have set the output source to AGC or M
2-14, the peak level will not be well controlled because no peak limiting
has been applied.
17. Set the digital output #1 level.
A) Press the N
EXT
B) [Skip this step if you are not using digital output #1.]
Turn the knob to set the desired digital output #1 level corresponding to
100% modulation, in units of dB below full-scale.
18. Set the digital output #2 level.
A) Press the N
EXT
B) [Skip this step if you are not using digital output #2.]
Turn the knob to set the desired digital output level #2 corresponding to
100% modulation, in units of dB below full-scale.
C) Press the N
EXT
If you activated the modulation setup tone in step (15.A) on page 2-16,
the tone will turn off automatically.
D) Press the N
EXT
19. Choose a processing preset.
A) Turn the knob until your desired preset is visible in the lower line of the dis-
play.
B) Press the R
ECALL
This step selects the processing to complement various program formats.
There are presets for radio-style and video style applications.
After this step, you can always select a different processing preset, pro-
gram the 6300 to automatically change presets on a time / date schedule,
use a GPI input to trigger preset changes, modify presets to customize
your sound, and store these presets as User Presets.
button.
button.
button.
button.
button.
N
EXT button to make your desired preset active.
O button.
in step 10 on page
ULTIBAND
2-17
INSTALLATION