Remote Control Interface Programming - Orban OPTIMOD 6300 Operating Manual

OPTIMOD 6300 DIGITAL

Remote Control Interface Programming

[Skip this step if you do not wish to program the GPI (contact closure) remote con-
trol interface.]
1. Navigate to S
2. Program one or more remote control interfaces.
A) Navigate to the desired Remote Interface button (1 through 4) by repeatedly
pressing the N
B) Hold down the button while turning the knob to select the desired function
for the interface.
Use either button below the appropriate graphics; both work the same.
A momentary pulse of voltage will switch most functions, except as
noted.

Preset Name: switches the named preset on the air. The control interface
can recall any factory or user preset.

Input: Analog: selects the analog inputs.

Input: Digital: selects the digital input and but does not apply deempha-
sis to it.

Input: Digital+J.17: selects the digital input and applies J.17 deemphasis
to it.

Bypass: switches the Bypass Test Mode on the air.

Tone: switches the Tone Test Mode preset on the air.

Exit Test: If a test preset is presently on the air, EXIT TEST reverts to the
previous processing preset.

Stereo: connects the 6300's left and right inputs to the left and right in-
puts of the processing and stereo-couples the processing.

Dual Mono: connects the 6300's left and right inputs to the left and right
inputs of the processing and removes all stereo coupling from the process-
ing so that the two channels of the processing operate as independent
processors, sharing only the active preset.
Both channels of the processing use the same preset.

Pass User Bits: When triggered, causes the 6300 to pass AES user bits
from its digital input to its digital output. See step 22 on page 2-19.

Block User Bits: When triggered, prevents the 6300 from passing AES
user bits from its digital input to its digital output.
> N > N
ETUP EXT ETWORK
button.
EXT
& R > R I
EMOTE EMOTE NTERFACE
INSTALLATION
.
2-45