Test Modes - Orban OPTIMOD 6300 Operating Manual

OPTIMOD 6300 DIGITAL
Bx Breakpoint: See page 3-54.
B1/B2 Crossover (Band 1 to Band 2 Crossover Frequency) sets the crossover fre-
quency between bands 1 and 2 to either 100 Hz or 200 Hz. It significantly affects the
bass texture and the best way to understand the differences between the two cross-
over frequencies is to listen.
Transient Enhance is mainly useful in mastering. This control allows you to insert
an audio delay in the sidechain of the 5-band compressor. By delaying the gain con-
trol signal, this allows attack transients to pass through the multiband compressor,
which can increase punch. There is a tradeoff between this control and the activity
of the look-ahead limiter, which will have to eliminate attack transients exceeding
the look-ahead limiter's threshold. For any material, there will be an optimum set-
ting for the T
RANSIENT
gering look-ahead limiter artifacts.
Loudness Threshold See page 3-51.
Loudness Controller Attack: See Loudness Control on page 3- 11.
Loudness Controller Bass Couple: See Loudness Control on page 3- 11.

Test Modes

Setup: Test
Parameter Labels
MODE
BYPASS GAIN
TONE FREQ
TONE LVL
TONE CHAN
The Test Modes screen allows you to switch between O
When you switch to B
will restore it when you switch back to O
set and did not yet save these changes as a User preset, you will not lose the edits
you made.
Table 3-12: Test Modes shows the facilities available, which should be largely self-
explanatory. The test modes function identically in stereo and dual-mono modes. For
E
NHANCE control that provides the most punch without trig-
Units Default
--- Operate
dB 0.0
Hz 400
% 91
--- L+R
Table 3-12: Test Modes
or T , the 6300 saves the preset you had active and
YPASS ONE
PERATE
Range (CCW to CW)
Operate, Bypass, Tone
18 ... +25
16, 20, 25, 31.5, 40, 50,
63, 80, 100, 125, 160,
200, 250, 315, 400, 500,
630, 800, 1000, 1250, 1600,
2000, 2500, 3150, 4000, 5000,
6300, 8000, 9500, 10000, 12500,
13586.76, 15000, 20000* [*44.1
kHz and higher output SR only]
0 ... 121
L+R, LR, LEFT; RIGHT
, B
PERATE
. Even if you had been editing a pre-
OPERATION
Step
---
1
LOG
1
---
, and T .
YPASS ONE
3-63