Automation Using The 5500'S Internal Clock - Orban OPTIMOD-FM 5500 Operation Manual

2-36
INSTALLATION

Automation Using the 5500's Internal Clock

K) Using a modulation monitor or modulation analyzer, adjust the DO 100% con-
trol to make the modulation monitor read 100% modulation (usually 75 kHz
deviation).
See the notes in step (8.D) on page 2-33.
10. End Analog and Digital I/O setup.
If you are using an external AGC and you temporarily set the E
step 1 on page 2-28, set the E
11. Select a processing preset.
See step 18 on page 2-20.
1. If you have not already done so, set the system clock.
[You can also set the clock automatically via PC Remote or the Internet. See
Synchronizing Optimod to a Network Time Server starting on page 2-46.]
A) Navigate to Setup > Next > T
a) Set hours and minutes.
b) Enter seconds slightly ahead of the correct time.
c) Wait until the entered time agrees with the correct time. Then press the
button to set the clock.
E T
NTER IME
B) Press the S D
ET ATE
a) Set today's date, using the days, month, and year buttons.
b) Press the E
NTER
C) Press the D
AYLIGHT
a) Using the Daylight Saving (DT M
and week when Daylight Saving Time (Summer Time) begins, or O
b) Using the Standard Time (ST M
and week when Daylight Saving Time (Summer Time) ends.
Note that setting DT M
defeat Daylight Time functionality.
c) Press the Escape key to back out of the daylight saving screen.
D) (Optional) Press the S
sign or call letters).
a) Use the knob to select characters. Use the Prev and Next buttons to move
the cursor.
AGC to Y
XT ES
D A
IME ATE ND
button.
D button.
ATE
button.
T
IME
ONTH
and ST W
ONTH
, DT W , ST M
ONTH EEK
ID button to specify your station's identifier (call
TATION
ORBAN MODEL 5500
XT
.
.
ID > S T
ET IME
and DT W ) buttons, set the month
EEK
) buttons, set the month
EEK
, or ST W
ONTH EEK
AGC to NO in
.
FF
to O will
FF