Orban OPTIMOD 6300 Operating Manual page 104

2-50
INSTALLATION
4. Specify the time sync parameters from your Optimod's front panel:
[Skip this step if you wish to specify the timeserver and time sync parameters
from your Windows XP computer.]
A) Press the T S
IME
The timeserver IP Address Screen appears.
a) Use the N
EXT
IP address. Use the knob to set the digit to the desired value. Repeat until
you have selected all the numbers in the desired IP address.
b) Press the S
AVE
B) Press the S N
YNC
should indicate that it is connecting to the IP address that you specified. When
the connection is successful, the Optimod's clock will automatically synchro-
nize to the timeserver.
 If the connection is not successful within five seconds, the display will indi-
cate that the connection failed. This means either that the timeserver is too
busy or that your setup cannot connect to the timeserver. Double-check the
IP address. If you are behind a firewall, make sure that port 123 is open.
 If your connection failed, the gateway might not be set correctly on your
Optimod. The gateway for the timeserver connection is the same gateway
that you set in step (1.D) on page 2-47. If you do not know the correct
gateway, you can often discover it by connecting a Windows computer to
the same Ethernet cable that is ordinarily plugged into your Optimod. As-
certain that the computer can connect to the Internet. At the command
prompt, type ipconfig. The computer will return the "Default Gateway."
5. Specify the time sync from the Optimod PC Remote software:
[Skip this step if you wish to specify the timeserver and time sync parameters
from your Optimod's front panel.]
Optimod PC Remote software can automatically set your Optimod's local time,
O , and T S
FFSET IME
PC Remote software.
If you are running Windows 2000, you cannot specify the timeserver from
your computer. However, you can still set your Optimod's clock and off-
set.
A) In Windows, navigate to the C
B) Set time zone to correspond to your local time zone.
C) In Windows, navigate to the C
tab.
D) If you are running Windows XP:
button.
ERVER
and P
keys to move the cursor in turn to each digit in the
REV
soft button to confirm your setting.
soft button to test your settings. Your Optimod's display
OW
to reflect the Windows settings in the machine running
ERVER
ONTROL
ONTROL
P > D T
ANEL ATE AND IME
P > D T
ANEL ATE AND IME
ORBAN MODEL 6300
> T Z
tab.
IME ONE
> I T
NTERNET IME