Programming Ways - Panasonic KX-TD816 Installation Manual

4.1.2 Programming Ways
Advancing to the next stage
When "SYS-PGM NO? ->" is displayed, you can select one of
the following:
l
To go to program [000], press the NEXT button.
. To go to another program, enter the 3-digit program address.
Rotation of jack number
Each jack of your Digital Super Hybrid System supports the
connection of a digital proprietary telephone and an analog device
with different extension numbers (extra Device Port: XDP
function). To program this function it is necessary to assign two
parts for each jack. The frost part of jack one is 01-l. The second
part of jack one is 01-2. The first part of jack two is 02-l and so
on. The NEXT and PREV buttons can be used to move from jack
to jack as required in programs [003], [004] and [601] through
[609].
Note
Storing your data
Example;
NEXT
NEXT
NEXT
#01-l
- - #Ol-2 7 #/02-l y-+
#KI2-2 . . . . . .
PREV PREV PREV
The first part of a jack is for a DPT of a XDP-assigned jack. The second
part is for a single line device. Program [600] "Extra Device Port"
assigns which jacks are XDl?
Press STORE to store your data.
l
The STORE indicator lights red and confirmation tone
sounds.
* C'onfirmation tone (one beep)
After pressing STORE, you will hear a beep. This informs you
that your storage is completed.
*
Alarm tone (three beeps)
If you hear the alarm, check that your entry is valid.
Making another selection within the same program address
l
To make the next higher selection, press
NEXT.
l
To make the previous selection, press
PREV.
l
To make a specific selection, press SELECT and then enter the
number.
System Programming
4-7