Panasonic KX-TD816 Installation Manual page 434

43
l
System Programming
Expansion Unit Type
(contd.)
109
3.
4.
5.
6.
7.
8.
9.
10,
To program "Slave," press NEST again.
Display example: Master:C ;El;E2
Keep pressing SELECT until the desired selection of Area
1
is displayed.
Press e to program another Area, if required.
Keep pressing SELECT until the desired selection of the
Area is displayed.
Repeat steps 4 and 5 until all the required entries are
completed, if required.
Press STORE.
If only one system is in operation, go to step 10.
Press NEXT to program the Slave System.
Display example: Slave :C ;El;E2
Repeat steps 3 through 7, if required.
Press END.
Conditions
.
.
.
There are
two
expansion areas
in
KX-TD8 16, areas
1
and 2 from
bottom to top. One 8Station Line Unit and one 4-CO Line Unit can be
installed.
There are three expansion areas in each system for KX-TDI 232, areas
I,2
and 3 from bottom to top. Up to two 8Station Line Units and one
4-CO Line Unit can be installed in each system.
An out-of-service system is unassignable. In this case, skip steps 8 and
9 for KX-TD1232.
In the case of KX-TD1232, if only the Slave System is in operation, the
display shows "Slave" in step 2.
'
After changing the setting, turn the Power Switch off and on once.
Otherwise, the previous setting will remain.
Feature References
Section 3, Features,
Module Expansion
47