Panasonic KX-TD816 Installation Manual page 74

2.4.4
Installing Expansion Unit
(KX-TD170 / KX-TDl80)
KX-TD816
The following procedures can be used to install either g-station
Line Unit (KX-TD 170) or 4-CO Line Unit (KX-TD180) for KX-
TD816.
The following steps 1 through 5 and 7 through 10 are common to
both expansion units.
The step 6 shows two different methods to install respective
1.
2.
expansion units.
Loosen two screws on the cover plate.
Insert fingers into the slits to remove the
cover plate.
3.
Note There are two cover plates. Any of
them can be removed, as needed.
Connect the cabinet cord to the
connector in the main unit firmly.
Hook the cabinet on the main unit and
slide the cabinet to the left until it is
fixed.
4. Loosen the outside screw and slide the
cover to the right.
screw
2-40
Installation