Panasonic KX-TD816 Installation Manual page 318

45
0
CO Line Programming
402
Dial Mode Selection
Description
Each CO line can be programmed for DTMF, pulse (rotary) or call
blocking. This program assigns your choice to each line.
DTMF': The dialing signals from an extension, either tone or pulse, are
converted to tone signals and transmitted to the CO line.
Pulse: The dialing signals from an extension, either tone or pulse, are
converted to pulse signals and transmitted to the CO line.
Call blocking: If your central office can receive both DTMF and pulse signals but
you are contracted for pulse, select this mode. When dialing on the
line with a touch tone telephone, only the pulse signals are sent to
the CO line.
Selection
l
CO line number:
KX-TD816; 01 through 08, * ( * =all CO lines)
KX-TD1232; 01 through 24, * ( * =a11 CO lines)
l
DTMF / Pulse / C. Block (call blocking)
Default
All CO lines - DTMF
Programming 1.
2.
3.
4.
5.
6.
7.
8.
Enter 402.
Display : CO Dial Mode
Press NEXT.
Display : CO Line NO?->
Enter a CO line number.
To enter CO line number
01, you can also
press
NEXT.
Display example: C001:DTMF
Keep pressing SELECT until the desired selection is
displayed.
Press STORE.
To
program another CO line, press NEXT or PREV, or
SELECT and the desired CO line number.
Repeat steps 4 through 6.
Press END.
Conditions
l
In the case of KX-TD1232, COO1
through
CO12 are for the Master
System and CO 13 through CO24 are for the Slave, if available.
l
To assign all lines to one selection, press the * key at step 3. In this
case, the display shows the contents programmed for COO 1.
l
If
DTMF is assigned, set the DTMF time of the line in program [404]
'DTMF Time."
l
If pulse or call blocking is assigned, set the pulse speed of the line in
program [403] "Pulse Speed Selection," and set the pulse break ratio
and inter-digit pause in program [990] "System Additional Information,
Field (17)" and in "Field (2 l)," if needed.
Feature References
Section 3, Features,
Dial Type Selection
System Programming 4-81