Flash Time - Panasonic KX-TD816 Installation Manual

413
45
0
CO Line Programming
Flash Time
Description
Assigns the length of the flash time. If your system is installed
behind a host PBX or Centrex line, External Feature Access (EFA)
is necessary to obtain their services. To enable it, select a required
hooking signal sending time for the CO line group.
Selection
l
CO line group (TRG) number: 1 through 8, *
( * =a11 CO line groups)
Default
l
Time (milliseconds): Disable (no EFA) / 80 / 96 / 112 / 200 / 300 /
400 / 500 / 600 / 700 / 800 / 900 / 1000 /
1100 / 1200
All CO line groups - 600 ms
Programming 1.
2.
3.
4.
5.
6.
7.
8.
Conditions
Enter 413.
Display: TRG Flask Time
Press NEXT.
Display: TRK GRP X0?->
Enter a CO line group number.
To enter CO line group number 1, you can also press NEXT.
Display example: 3.Gl: 600msec
Keep pressing SELECT until the desired time is displayed.
Press STORE.
To program another CO line group, press NEXT or PREV, or
SELECT and the desired CO line group number.
Repeat steps 4 through 6.
Press END.
. You may disable EFA. if not required. The Flash feature will be in
effect in place of EFA. Program [414] "Disconnect Time" is used to
select the time required for the Flash feature.
._
l
The flash time required is determined by the central office or the host
PBX lines.
l
To assign all CO line groups to one selection, press the * key at step 3.
In this case, the display shows the contents programmed for CO line
group 1.
l
Program [401] "CO Ljne Group Assignment" is used to assign each CO
line to a CO line group.
Feature References Section 3, Features,
External Feature Access
Flash
4-92 System Programming