Panasonic KX-TD816 Installation Manual page 243

4.1.1
Using the Proprietary Telephone.
Viewing the Display
The display gives you helpful information, such as what you should
do now, what you have done, etc..
The KX-T7230 and the KX-T7235 both utilize two information
lines for programming. The upper line is called the Message Line
and the lower one is called the Function Line.
The Message Line (upper) shows you what you should do or what
you should select. It also allows you to confirm what you have just
entered. The display capacity is 16 digits. If your entry exceeds
the capacity, you can shift the display by pressing + or t button.
The Function Line (lower) shows the current function of the soft
buttons. These functions change with the programming procedures.
jSYS-PGM NO? y_ 11
KX-T7230 Display
+- Message Line
6 Function Line
/
SXS-FGM NO? ->
+ Message Line
+ Function Line
KX-T7235 Display
Before entering the programming mode
Before entering programming mode, confirm that:
l
Your telephone is on-hook.
l
No calls are on hold at your telephone.
Entering the programming mode
Notes
Press PROGRAM (or PAUSE) + * + # and enter your System
Password (default=1234).
l
The display shows the Initial Message:
SYS-PGM NO? - >
l
If
your telephone set has no PROGRAM button, substitute the PAUSE
button.
l
If nothing is entered in five seconds after the PROGRAM (or PAUSE)
button is pressed, it is cancelled.
l
The System Password entered is not shown on the display. The System
Password can be changed by System Programming. Refer to Section
4.3
[
1071 "System Password."
l
During the programming mode, your extension is treated as a busy
extension.
l
Only one proprietary telephone can be in programming mode at any
one time.
4-6
System Programming