EAM30060
REMOVING THE LOWER BRACKET
1. Use a maintenance stand to raise the front
wheel off the ground.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Ring nut "1"
TIP
Remove the ring nut with the steering nut
wrench "2".
Steering nut wrench
90890-01403
Exhaust flange nut wrench
YU-A9472
EWA13730
WARNING
Securely support the lower bracket so that
there is no danger of it falling.
EAM30061
CHECKING THE STEERING HEAD
1. Wash with kerosene:
• Bearing
• Bearing race
2. Check:
• Bearing
• Bearing race
Damage/pitting Replace.
3. Replace:
• Bearing
• Bearing race
a. Remove the bearing race from the steer-
ing head pipe with a long rod "1" and a
hammer.
b. Remove the bearing race from the lower
bracket with a chisel "2" and a hammer.
c. Install a new bearing race.
ECA14270
NOTICE
If the bearing race is not installed properly,
the steering head pipe could be damaged.
TIP
Always replace the bearing and the bearing race
as a set.
4. Check:
• Upper bracket
• Lower bracket
(along with the steering stem)
Bends/cracks/damage Replace.
EAM30062
INSTALLING THE STEERING HEAD
1. Install:
• Lower bearing "1"
TIP
Apply the lithium-soap-based grease on the dust
seal lip and bearing inner circumference.
4-57
STEERING HEAD