Replacing The Pick-Up Roller - Konica Minolta bizhub C353 Service Manual

2. Periodical check
[2]
13. Repeat steps 1 to 12 similarly for the 4th drawer.
2.1.3

Replacing the pick-up roller

A. Periodically replaced parts/cycle
• Pick-up roller: Every 300,000 prints
NOTE
• Replace the separation roller assy, feed roller and pick-up roller at the same time.
B. Replacing procedure
1. Remove the rear right cover. (Remove the right lower cover for 4th row.)
See P.13
2. Remove the tray3. (Remove the tray4 from 4th row.)
3. Remove the separation roller mounting bracket assy.
See the procedures 1 to 3 in P.3 "Replacing the separation roller assy."
8
[1]
A093F2C531DA
[2]
[1]
A093F2C002DA
Field Service Ver. 2.0 Jan. 2008
12. Remove the C-ring [1] and remove
the feed roller [2].
4. Disconnect the connector [1] and
remove the harness from two wire
saddles [2].