System Parameter And Data Lists (Smc Lists); Memory All Clear (Sp5-801) - Gestetner A294 Service Manual

SERVICE PROGRAM MODE

4.2.6 SYSTEM PARAMETER AND DATA LISTS (SMC LISTS)

1. Access the SP mode corresponding to the list that you wish to print.
1) SP5-990-1: All system parameter list
2) SP5-990-2: SP mode data list
3) SP5-990-3: UP mode data list
4) SP5-990-4: Machine status history data list
2. Touch the "Copy Mode" key to access the copy mode display.
3. Select the paper size and press the "Start" key to print the list.
4. After printing the list, exit the copy mode display by touching the "SP Mode"
key.
5. Exit SP mode.

4.2.7 MEMORY ALL CLEAR (SP5-801)

NOTE: Memory All Clear mode resets all the SP mode settings stored in the
NVRAMs on the SICU and the BCU to their default settings except for SP7-
003-1 (Electrical total counter value).
There are three RAM clear modes which can be selected after entering
SP5-801.
1) Clear all data in the NVRAMs on the SICU and BCU.
2) Clear the data in the NVRAM on the SICU.
3) Clear the data in the NVRAM on the BCU.
Among the settings that are reset are the correction data for process
control and all the software counters.
Normally, this SP mode should not be used. This procedure is required
only after replacing the NVRAM or when the copier malfunctions due to a
damaged NVRAM.
1. Print out all SMC Data Lists (SP mode 5-990-1).
2. Access SP mode 5-801, and select 1, 2, or 3 for the required RAM clear mode.
3. Press "Start" on the display. At this time the beeper will sound.
4. A confirmation message will be displayed, then press "Yes" .
5. Turn the main power switch off and back on.
6. Do the printer and scanner registration and magnification adjustments (see
Replacement and Adjustment – Copy Image Adjustments).
7. Referring to the SMC data lists, re-enter any values which had been changed
from their factory settings.
8. Do SP3-001-2 (ID Sensor Initial Setting). If the SICU data was cleared, also do
SP4-911-1 and 4-912-1 (HDD media tests). Note that the HDD media tests will
delete copy server and stamp data on the disks.
9. Check the copy quality and the paper path, and do any necessary adjustments.
A294/A295
CÓPIA NÃO CONTROLADA
4-70
CÓPIA NÃO CONTROLADA
Rev. 6/2000
SM