Pressure Roller Cleaning Roller Replacement - Gestetner A294 Service Manual

6.9.8 PRESSURE ROLLER CLEANING ROLLER REPLACEMENT

[D]
[C]
[B]
[A]
A294R505.WMF
1. Remove the screw [A] through the hole [B] in the fusing unit exit inner cover as
shown.
2. Pull the pressure cleaning roller unit [C] to the front, then swing the pressure
roller cleaning roller unit down clockwise.
3. Pull out the pressure roller cleaning roller unit again. The pressure roller
cleaning roller unit dislodges from the pins [D] on the front and rear side plate
of the fusing exit.
4. Remove the two plate springs [E] (2 screws) and replace the pressure roller
cleaning roller (1 spacer [F], 1 ball bearing [G] and 1 shaft assembly [H]).
NOTE: When re-installing the pressure roller cleaning roller unit, fit the holes [I]
(first the rear, then the front) in the pressure roller cleaning roller unit
bracket onto the pins [D] on the rear and front side plates of the fusing unit
exit. Then, turn the pressure roller cleaning roller unit counterclockwise,
and push the pressure roller cleaning roller unit to the rear. Finally, secure
it with the screw [A].
SM
CÓPIA NÃO CONTROLADA
[I]
[E]
[F]
[G]
6-93
CÓPIA NÃO CONTROLADA
[D]
[H]
FUSING UNIT
[E]
A294R506.WMF
A294/A295