Gestetner A294 Service Manual page 374

DEVELOPMENT AND TONER SUPPLY
[A]
[B]
[C]
A294R541.WMF
6. Clean the side seals [A] and entrance seal [B].
NOTE: Cover the sleeve rollers with a sheet of paper [C] to prevent the used
developer from being attracted to the sleeve rollers.
7. Pour in one pack of developer [D] evenly across the width of the development
unit, while turning the knob [E].
8. Re-install the toner hopper, then re-assemble the machine.
NOTE: 1) Be sure to connect the connectors after installing the development
unit in the machine.
2) Tilt the toner hopper so that there is toner near the toner hopper
sensor.
9. Turn on the main switch, then do developer initial setting (SP mode No. 2-801).
NOTE: 1) Do not make any copies with the new developer before completing
the developer initial setting, otherwise toner density control will be
abnormal.
2) If the developer initial setting did not complete correctly, you cannot
exit the SP mode by pressing the "Quit" key. If this problem occurs,
turn the main switch off and on, then perform the initial setting again.
If the result is the same, see "SC342" in the troubleshooting section.
A294/A295
CÓPIA NÃO CONTROLADA
[A]
[B]
6-44
CÓPIA NÃO CONTROLADA
[D]
[E]
A294R407.WMF
SM