Table of Contents
Advertisement
ENERGY SAVER MODES
2.12.2 ENERGY SAVER (PANEL OFF) MODE
Entering Energy Saver (Panel Off) Mode
The machine enters energy saver mode (also known as 'panel off mode') when
one of the following is done.
• The panel off timer runs out after the end of a job.
NOTE: If the panel off timer is 0, the machine will wait for the energy saver timer
to run out, and then it will go straight to low power mode (see Low Power
Mode).
• The Energy Saver key is held down for a second.
What Happens in Energy Saver (Panel Off) Mode
When the machine enters energy saver (panel off) mode, the fusing unit
temperature stays at 173°C and the operation panel indicators are turned off
except for the Energy Saver LED and the Power LED. There is only one energy
saver level.
If the CPU receives the image print out command from an application (e. g. to print
data from a PC), the fusing temperature rises to print the data. However, the
operation panel stays off.
Return to Stand-by Mode
If one of the following is done, the machine returns to stand-by mode:
• The Energy Saver key is pressed
• Any key on the operation panel is pressed
• An original is placed in the ADF
• The ADF is lifted
The recovery time from energy saver to rise the fusing temperature is about 0 s.
NOTE: The polygon motor needs 10 seconds to reach the correct speed.
Operation
Mode
Switch
Energy Saver
A294/A295
CÓPIA NÃO CONTROLADA
Energy
Saver LED
On
On
2-120
CÓPIA NÃO CONTROLADA
Fusing
System +5 V
Temp.
173°C
On
Main Power
LED
On
SM
Advertisement
Table of Contents
Troubleshooting
