Original Skew Correction - Gestetner A294 Service Manual

2.1.7 ORIGINAL SKEW CORRECTION

[A]
The transport belt motor remains energized to carry the original about 7 mm past
the left scale [A] (see the middle drawing). Then the motor stops and reverses to
feed the original back against the left scale (see the bottom drawing). This forces
the original to hit the left scale, which aligns the trailing edge to minimize original
skew on the exposure glass.
If thin original mode is selected, the original is not forced back against the left
scale. This is to prevent damage to the original.
After a two-sided original has been inverted to copy the 2nd side, it is fed in from
the inverter against the left scale (see the bottom drawing; the top two drawings do
not apply in this mode).
The amount of reverse feed against the left scale can be adjusted with SP modes.
SM
CÓPIA NÃO CONTROLADA
7 mm
2-7
CÓPIA NÃO CONTROLADA
DOCUMENT FEEDER
B301D500.WMF
A294/A295