Program Download - Gestetner A294 Service Manual

PROGRAM DOWNLOAD

4.4 PROGRAM DOWNLOAD
The flash memory card holds two programs, one is for the SICU and the other is for
the BCU. Both programs can be downloaded from the slot in the SICU (the
program for the BCU is transferred from the SICU).
There is also a function to download the program from the SICU to a flash memory
card. However, the BCU program cannot be downloaded to a flash memory card.
NOTE: The procedure for how to write the source software from a flash memory
card writer to a flash memory card is described in the SwapBox FTL
manual.
Download to the SICU and BCU
NOTE: The program for the SICU and the program for the BCU can be
downloaded separately. However, both programs should be updated at the
same time to prevent mismatching of the programs.
A294M900.WMF
1. Turn off the main power switch.
2. Remove the flash memory card cover [A]. If the optional LCT is installed, open
the left cover [B] of the LCT.
3. Plug the flash memory card [C] into the card slot in the SICU.
NOTE: Make sure that the surface printed "A" faces upwards.
4. Turn on the main power switch.
5. Touch "Install" to download the SICU software. The machine erases the current
software, then writes the new software to the SICU.
6. Touch "Install" to download the BCU software. The machine erases the current
software, then writes the new software to the BCU.
If downloading from the flash card to the SICU failed, an error message appears on
the display. At this time, touch the "OK" key to re-try the download.
A294/A295
CÓPIA NÃO CONTROLADA
[B]
[C]
[C]
[A]
4-78
CÓPIA NÃO CONTROLADA
A294M025.WMF
SM