Using The Supporting Pillar For Dia-Illuminator 100W (Ma2-Dp); Procedure For Turning On The Power Switch - Nikon ECLIPSE MA200 Instructions Manual

3.23

Using the supporting pillar for dia-Illuminator 100W (MA2-DP)

Attach the supporting pillar for dia-Illuminator 100W to the MA200 main body to perform the microscopy under
the diascopic illumination.
To perform the microscopy, mount the D-LH/LC Lamphouse and condenser etc. to the supporting pillar for
dia-Illuminator 100W, and connect the power supply (TI-PS 100W) to the lamphouse.
3.23.1

Procedure for turning on the power switch

Light intensity
control dial
Figure 3.23-2 Procedure for turning on
the power switch
Chapter 3 Operation Details
Figure 3.23-1 Supporting pillar for dia-Illuminator 100W
2
Power switch ON
POWER indicator
1
Power switch ON
Lamphouse
Filter slider
Supporting pillar for
dia-Illuminator 100W
Condenser mount
Condenser
Power supply
1 Be sure that the lamphouse on the supporting
pillar for dia-Illuminator is properly connected to
the power supply, and the brightness control dial
on MA200 main body is set to OFF.
2 Set the POWER switch to the "|" side on the power
supply.
The POWER indicator on the power supply and
the lamp light up.
3 Set the POWER switch to the "|" side to turn on
the MA200 main body.
The power LED on the front lights up.
4 To turn off the pillar illuminator, set the power
switch to the " " side in the sequence of the fiber
illuminator, the MA200 main body.
* To adjust the brightness of the diascopic
illumination or to use the TI-PS 100W power
supply in detail, refer to the instruction manual
supplied with the equipment.
57