Nikon ECLIPSE MA200 Instructions Manual page 19

Set the microscope for the bright-field microscopy under the episcopic illumination.
If the current unit is the one shown in the column at the right edge under "Other items required" in Table 2.1,
pull out each item from the optical path.
2-1
2-2
2-5, 6
2-4
2-6
2-7
Place the sample onto the stage and adjust the focus and the brightness.
3-2
3-3
Adjust the diopter and the interpupillary distance.
Chapter 2 Microscopy
1 Push in the optical path changeover lever for the
2-4
2 Push in the eyepiece tube/back port changeover
3 Push in the BD field changeover lever to select the
4 Turn the revolving nosepiece to place the 10X
5 Place the NCB11 filter in the filter turret into the
2-3
6 Adjust the brightness roughly with the brightness
7 Turn the field diaphragm dial and the aperture
1 Use the sample holder according to the selected
3-1
2 Turn the coarse/fine focus knobs and focus on the
3 Turn the brightness control dial to adjust the
3-1
1 Adjust the interpupillary distance. (See 3.5.)
2 Adjust the diopter. (See 3.6.)
17
eyepiece tube and select 100% for the binocular
eyepiece. (See 3.4.1.)
lever to select 100% for the eyepiece tube. (See
3.4.1.)
"BF (bright-field)" position. (See 3.3.)
objective into the optical path. (See 3.9.2)
The nosepiece addresses (1 to 7) on the
front-display light up to indicate the position of the
revolving nosepiece. (See 3.9.3.)
optical path and compensate color temperature.
(See 3.10)
control dial and the desired ND filter in the filter
turret. (See 3.2.1 and 3.10.)
diaphragm dial counter-clockwise to the limit to
fully open the field diaphragm and the aperture
diaphragm for the episcopic illumination. (See 3.11
and 3.12.)
sample. Place the sample onto the stage and
move the stage using the stage movement knob
for the X/Y direction so that the observation
position comes to the center of the view-field. (See
3.8.)
target. (See 3.7.)
brightness of the episcopic illumination. (See
3.2.1.)