The Lv-Lh50Pc Lamphouse And The Lamp; Attaching The Lamphouse - Nikon ECLIPSE MA200 Instructions Manual

4.4

The LV-LH50PC Lamphouse and the Lamp

CAUTION for heat
Do not touch the lamp and the lamphouse while the lamp is on or for thirty minutes after it has been
turned off.
CAUTION
• To prevent electrical shock and damage to the microscope, always turn off the power switch (set the
switch to the "O" side) and unplug the power cord from the outlet before attaching or detaching the
lamphouse or replacing the lamp.
• To prevent burn injury, allow the lamp and the lamphouse to cool down completely (for at least 30
minutes after the lamp is turned off), before replacing lamps or attaching/detaching the lamphouse.
• Never touch the glass surface of the lamp with bare hands. Doing so will cause fingerprints, grease,
etc., to generate ghost images on the lamp surface, reducing the illumination. If you do get any
fingerprints or dirt on the lamp, wipe them clean.
• Make sure the lamphouse cover is securely fitted to the lamphouse after replacing lamps. Never
turn on the lamp with the lamphouse cover removed.
• When you dispose of the replaced lamp, do not break it. Instead, dispose of the used lamp as
industrial waste or dispose of it according to the local regulations and rules.
4.4.1

Attaching the lamphouse

(4)
Chapter 4 Assembly
(1)
(2)
1 Fully loosen the clamp screw on the upper side of
the lamphouse connecting sleeve by using the
supplied hexagonal screwdriver.
2 Mount the lamphouse to the connection port on
the rear of the product and insert the lamphouse to
the limit.
3 Using the hexagonal screwdriver, tighten the
clamp screw on the upper side of the connector of
the lamphouse to secure it.
4 Plug the cable coming from the lamphouse into
the lamphouse connector [LAMP DC12V 50W] on
the rear of the product and tighten the ring of the
connector to secure the connection.
77