Nikon ECLIPSE MA200 Instructions Manual page 92

■
Attaching the ELWD-S condenser
Dovetail
Condenser
indication
position
Attach the D-LH/LC Lamphouse to the supporting pillar for dia-Illuminator 100W.
Insert hexagonal
screwdriver and
tighten clamp screw.
Chapter 4 Assembly
Condenser
clamp screw
ELWD-S condenser
Lamphouse
clamp screw
Cable clamp
With the indication on the turret facing the front
(towards the user), insert the condenser turret into the
bottom of the condenser holder, and secure it by
tightening the condenser clamp screw.
1 Insert the lamphouse into the lamphouse mount at
the top of the supporting pillar for dia-Illuminator.
Align the positioning pin on the dia pillar
illuminator with the groove on the cylinder of the
lamphouse.
2 Insert a hexagonal screwdriver into the hole on the
top of the supporting pillar for dia-Illuminator.
Secure the lamphouse by tightening the
lamphouse clamp screw.
3 Secure the lamphouse cable with the cable clamp
on the back of the supporting pillar for
dia-Illuminator.
The cable clamp is attached to the supporting
pillar for dia-Illuminator with the hooks on its sides.
To remove the cable clamp, push in the hooks
from the sides.
The cable clamp can hold up to four cables.
90