Warning - Nikon ECLIPSE MA200 Instructions Manual

Inverted metallurgical microscope
Table of Contents

Advertisement

WARNING

1.
Intended product use
The product should only be used for microscopic observation. Do not use this microscope for other purposes.
Additionally, do not try to put a large sample on the stage if it is larger than the stage.
2.
Do not disassemble
Disassembling the microscope or the microscope system may result in electric shock or malfunctions.
Damage or injury that may occur due to mishandling is unwarranted. Never attempt to disassemble any part
other than the parts described in this manual. If you experience problems with the microscope or the
microscope system, contact your nearest Nikon representative.
3.
Read the instructions carefully
To ensure safety, carefully read this manual and the manuals for other equipment used with this microscope.
In particular, observe all
4.
Ratings of the power supply
The power supply circuit in this product is designed for AC power of 100 to 240 VAC and 50/60 Hz. Before
connecting the power cord, check that the power supply to be used conforms to the voltage and frequency
described above. Use of a non-conforming power line may result in equipment malfunction, failure or fire.
5.
Power cord
Be sure to use the specified power cord for the product. Using a wrong power cord may result in malfunctions
or fire. The product is classified as subject to Class I protection against electrical shock. Make sure it is
connected to an appropriate ground terminal (protective earth terminal). To prevent electrical shock, always
turn off the power switch (set the switch to the " " position) for the product before connecting or
disconnecting the power cord. For specifications of the power cord, refer to "7. Specifications."
6.
Specified light source
Use this product with a specified light source. The specified light source devices are shown as follows:
For the episcopic illumination
• Lamphouse
Nikon 12V 50W Precentered Lamphouse (model name: LV-LH50PC)
• Lamp
Nikon 12V 50W longlife halogen lamp (model name: LV-HL50W) or 12V 50W shortlife halogen lamp from
other manufacturers (model name: OSRAM HLX 64610, OSRAM HLX 64611, or PHILIPS 7027).
For the diascopic illumination
• Lamphouse
Nikon 12V 100W Precentered Lamphouse LC (model name: D-LH/LC)
• Lamp
Nikon 12V 100W halogen lamp (model name: OSRAM HLX 64623 or PHILIPS 77241).
• TI-PS 100W power supply
If you wish to buy these lamps, please contact your nearest Nikon representative.
Safety Precautions
warnings and
cautions given at the beginning of each manual.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents