Cable Connection For The Manual Revolving Nosepiece And The Ma200; Connecting The Motorized Nosepiece And The Nosepiece Controller 2 - Nikon ECLIPSE MA200 Instructions Manual

4.5.2

Cable connection for the manual revolving nosepiece and the MA200

Connect the cable of the revolving nosepiece to the connector on the microscope.
Square connector
Round connector
* The address information for the revolving nosepiece is displayed on the MA200 front display via cable
connection. Additionally, the address information can be output to a device including a PC or the DS-L2 via
USB connection.
4.5.3

Connecting the motorized nosepiece and the Nosepiece Controller 2

Make sure to turn off the motorized Nosepiece Controller 2 to attach or remove the signal cable.
Chapter 4 Assembly
1 Loosen the rear-panel clamp screw on the
microscope with the supplied hexagonal
screwdriver to remove the rear-panel.
2 Connect the cable of the revolving nosepiece to
the connector on the microscope.
Connect the cable of the MA2-NUI5 revolving
nosepiece to the round connector on the
microscope.
Connect the cable of the D-ND6/D-NI7 revolving
nosepiece to the square connector.
3 Secure the clamp screw to reattach the
rear-panel.
1 Loosen the rear-panel clamp screw on the
microscope with the supplied hexagonal
screwdriver to remove the rear-panel.
2 Remove the cap from the signal cable hole on the
rear-panel.
3 Pass the signal cable for the LV-NCNT2
Nosepiece Controller 2 through the hole of the
rear-panel, then connect it to the cable of the
revolving nosepiece.
4 Secure the clamp screw to reattach the
rear-panel.
5 Connect the signal cable to the motorized
nosepiece connector on the LV-NCNT2.
6 Connect the LV-NCNT2 to the [NCNT] connector
on the MA200 main body using the RS232C cross
cable.
79