Epson Stylus Pro GS6000
5.5.2 Paper Feed Adjustment
This is to adjust the paper feeding amount.
Required Tool
Ruler (that can measure 1,000 mm)
Paper Used
Size:
1250 mm
Type:
Marking Film
Standard Value
980 mm ± 10 mm
Procedure
1.
Refer to
?5.1.6 Cautions and Preparation for Pattern Printing?
prepare for printing the pattern.
2.
Select
Adjustment
=>
Feed Adj. +Side
[Enter] button to print an adjustment pattern.
3.
Measure the length indicated on the figure.
C A U T I O N
Be sure to place the adjustment pattern print on a flat surface when
performing the measurement.
4.
Enter the measured value and press the [Enter] button.
5.
Print the adjustment pattern again and check that the length is the specified
value.
C H E C K
Using the PAPER FEED ADJUST in the user mode, the paper feed
P O I N T
adjustment can be carried out using the paper used by the user for
each user defined paper setup.
ADJUSTMENT
(p.197), and
=>
[Enter]
Print, and press the
PF Related Adjustments
TOP MecNo. XXXXXXXXXX Date&Time (YY - MM - DD HH : MM : SS)
Figure 5-38. Adjustment Pattern
Revision F
xx - xx - xx xx : xx : xx
223
Confidential