Download Print this page

Epson Stylus Pro GS6000 Pre-Installation Guide Installation Manual

Epson stylus pro gs6000
Hide thumbs Also See for Stylus Pro GS6000 Pre-Installation Guide:

Advertisement

The estimated setup time for the Epson Stylus Pro GS6000 is 2 to 3 hours. Make sure you have six or more people available
to help lift and guide the printer onto its stand. Follow these guidelines:
Space Requirements
The printer, stand, and take-up roller come on a pallet that weighs 781 lb (354 kg), with its dimensions shown below.
Make sure you can move the equipment from your receiving area to the printer's final location. For example, make sure
it will fit inside an elevator, through doorways, and around corners. Keep the printer horizontal as much as possible.
The amount of space required to use the printer is shown below, but you'll need a larger space to assemble it. Clear a large
floor space before unpacking. Be sure to leave enough space behind the printer to load ink and media.
Environmental Requirements
The Epson Stylus Pro GS6000 can be installed in any location with a typical air conditioning or air ventilation system.
No special air purification system is required. Avoid placing the printer near a vent that would blow directly on it.
Additional information about ink cartridge safety is provided in the Material Safety Data Sheets online at
www.proimaging.epson.com.
Epson Stylus
Pre-installation Checklist
52 ½ in.
(133 cm)
43 in.
(109 cm)
150 in.
(380 cm)
®
Pro GS6000
115 ½ in.
(293 cm)
108 in.
(275 cm)
61 in.
(155 cm)

Advertisement

loading

Summary of Contents for Epson Stylus Pro GS6000 Pre-Installation Guide

  • Page 1 Pro GS6000 Pre-installation Checklist The estimated setup time for the Epson Stylus Pro GS6000 is 2 to 3 hours. Make sure you have six or more people available to help lift and guide the printer onto its stand. Follow these guidelines: Space Requirements The printer, stand, and take-up roller come on a pallet that weighs 781 lb (354 kg), with its dimensions shown below.
  • Page 2: Electrical Requirements

    You may also need a box cutter to unpack the printer and to cut media, a loupe to read alignment patterns, and a spectrophotometer to linearize your color output. Epson and Epson Stylus are registered trademarks, and Epson Exceed Your Vision is a registered logomark of Seiko Epson Corporation. Other product names are the property of their respective owners.