Epson Stylus Pro GS6000 Service Manual page 100

Epson Stylus Pro GS6000
4.4.4.2 TERMINAL BLOCK
C H E C K The unit of ASP includes the Clear Cover, Short Pins, and the
P O I N T
TERMINAL BLOCK.
1. Remove the MAINTENANCE COVER ASSY (both).
2. Remove the MAINTE COVER, B (both).
3. Remove the PAPER GUIDE COVER (both).
4. Remove the After Heater Cover.
5. Remove the Clear Cover.
Inside the After Heater Cover
TERMINAL BLOCK
Figure 4-42. Removing the Clear Cover
DISASSEMBLY & ASSEMBLY
(p91)
(p92)
(p94)
(p97)
Clear Cover
Disassembly and Assembly Procedure
6. Remove the four screws that secure four cables on the left.
A) Silver, Phillips, Pan with S.W& Square washer M2x8: four screws
7. Disconnect the cables and remove the two short pins.
8. Remove the two screws on the right and disconnect the two cables.
B) Silver, Phillips, Pan with S.W& Square washer M2x8: two screws
9. Remove the two screws and remove the TERMINAL BLOCK.
C) Silver, Phillips, Pan machine screw M4x6: two pieces
Inside the After Heater Cover
A
B
C
Figure 4-43. Removing the TERMINAL BLOCK
When reassembling the TERMINAL BLOCK on the left, first set
the Short Pins, then attach the cables as shown in the figure above.
Revision F
TERMINAL BLOCK
Short Pins
100
Confidential