Epson Stylus Pro GS6000 Service Manual page 128

Epson Stylus Pro GS6000
4.4.7.5 CR ENC ASSY
1. Remove the TOP COVER (left only).
2. Remove the MAINTE COVER T.
3. Remove the SIDE COVER (left only).
4. Remove the IH COVER (left only).
5. Unlock the Carriage. (p83)
6. Remove the CR Top Cover (Step 6 to 9 in 4.4.5.3 COOLING FAN).
7. Disconnect all the connectors except J13 and J14 and release the cables from the
clamps on top.
As seen from the top
SUB_A BOARD ASSY
Figure 4-89. Disconnecting the cables
DISASSEMBLY & ASSEMBLY
(p85)
(p86)
(p89)
(p90)
(p104)
.
Carriage
J14 J13
Disassembly and Assembly Procedure
8. Move the Carriage to the platen, and remove the four screws from the hole on the rear left.
A) Silver, Phillips, Cup M3x6: two pieces
B) Silver, Phillips, Pan with S.W & P.W M3x8: two pieces
As seen from the rear
A
Figure 4-90. Removing the screws from the hole on the rear
9. Move the Carriage to the left end and remove the five screws (one securing the
GND terminal together).
A) Silver, Phillips, Pan with S.W & P.W M3x8: four pieces
B) Silver, Phillips, Cup M3x6: one piece
10. Release all the cables from the clamps on the side.
As seen from the top
SUB_A BOARD
Top Frame
A
B
Figure 4-91. Removing the screws on the Top Frame
Revision F
.
As seen from the rear
B
[Step 12]
Open it to the left
Clamps
Confidential
128