Housing - Epson Stylus Pro GS6000 Service Manual

Epson Stylus Pro GS6000

4.4.3 Housing

4.4.3.1 TOP COVER
C H E C K
Basically you can remove this part on the left and the one on the
P O I N T
right in the same way. Therefore this section describes the way to
remove the one on the right only.
1. Remove the two screws on the rear.
A) Silver, Phillips, Pan with S.W & P.W M4x8: two pieces
2. Slide the TOP COVER to the rear and remove it.
As seen from the rear
TOP COVER (right)
A
Figure 4-15. Removing the TOP COVER
C H E C K When attaching the TOP COVER (right), make sure to set the
P O I N T
front left of it under the ALARM LED COVER.
DISASSEMBLY & ASSEMBLY
ALARM LED
A
A
See Figure 4-15.
Disassembly and Assembly Procedure
When installing the TOP COVER, make sure to engage the hooks
on both sides to their positioning holes.
Inside
TOP COVER (inside)
Hook
1
2
Positioning hole
Revision F
85
Confidential