Cr Height Adjustment - Epson Stylus Pro GS6000 Service Manual

Epson Stylus Pro GS6000

5.3.3 CR Height Adjustment

This allows you to adjust the height of the Carriage (CR CURSOR ASSY).
Required Tool
PG ADJUSTMENT JIG
Standard value
Determined by the jig.
Parts need to be removed in advance
CARRIAGE COVER
Procedure
1. Open the front cover.
2. Unlock the carriage unit. ?4.4.1.1 Unlocking the Carriage? (p.83)
3. Put the PG ADJUSTMENT JIG on the platen, on the left of the CR.
Place the
PG ADJUSTMENT JIG
when the carriage unit is moved.
4. Set the head height adjustment lever to the low position.
5. Move the carriage unit from the home position side toward the jig.
6. Check that the carriage unit passes through over the lower section (1.3mm)
and contact the higher section (1.4mm).
7. Move the jig on the other side of the CR (right), and move the carriage unit
from the side opposite to the home toward the jig.
8. Check that the carriage unit passes through over the lower section (1.3mm)
and contact the higher section (1.4mm).
ADJUSTMENT
so that the PRINT HEAD goes just above it
CR Related Adjustments
PG ADJUSTMENT JIG
1.4mm 1.3mm
Figure 5-20. Checking the Height of carriage unit
PG HEIGHT JIG
Figure 5-21. Detail view
Revision F
Touch Nozzle Plate
Confidential
204