Ink System Mechanism - Epson Stylus Pro GS6000 Service Manual

Epson Stylus Pro GS6000

4.4.11 Ink System Mechanism

4.4.11.1 PRINT HEAD/VALVE ASSEMBLY, HEAD
C H E C K
There are two heads, but basically you can remove both heads in
P O I N T
the same way. Therefore this section describes the way to remove
one of the heads only.
When replacing the PRINT HEAD, make sure to replace the
C A U T I O N
VALVE ASSEMBLY, HEAD together.
It is also recommended to replace the HEAD WIPER and the
HEAD CAPS if they are not in good condition (Dried ink).
1. Unlock the Carriage. (p83)
2. Remove the TOP COVER (left only).
3. Remove the MAINTE COVER T.
4. Remove the CR Cover (Step 4 to 6 in 4.4.5.3 COOLING FAN).
5. Remove the four screws and remove the Left Front Plate (not an ASP).
A) Silver, Phillips, Pan with S.W & P.W M4x8: four screws
As seen from the front
Figure 4-129. Removing the Left Front Plate
DISASSEMBLY & ASSEMBLY
(p85)
(p88)
(p104)
Left Front Plate
Disassembly and Assembly Procedure
6. Move the Carriage back to the left end.
7. Remove the two screws and remove the two grounding wires.
A
Grounding wires
Screws
Figure 4-130. Removing the grounding wires
Revision F
158
Confidential