Epson Stylus Pro GS6000 Service Manual page 172

Epson Stylus Pro GS6000
4.4.11.9 SUB TANK ASSY
1. Discharge ink using the service program.
2. Remove the TOP COVER (L or R).
3. Remove the PANEL COVER, T
4. Remove the SIDE COVER (L or R).
5. Remove the IH COVER (L or R).
6. Remove the TWO WAY VALVE ASSY.
7. Remove the SUB TANK SENSOR.
8. Disconnect the connector for the solenoid.
9. Release the cables from the 3 clamps.
Clamps
Figure 4-149. Releasing the cable
DISASSEMBLY & ASSEMBLY
(p210)
(p85)
(p86) or the MAINTE COVER T (p88).
(p89)
(p90)
(p170)
(p131)
Connector of the solenoid
Disassembly and Assembly Procedure
10. Disconnect the front and rear tubes from the SUB TANK ASSY.
Tube
SUB TANK ASSY
Figure 4-150. Removing the SUB TANK ASSY
The tube connectors include "O-RINGs" (black rubber rings). To
prevent any leak, those O-RINGs have to be replaced with new
ones if the connectors are once opened.
C H E C K
Detach the assy one by one to the target assy from the outside to the
P O I N T
inside.
A D J U S T M E N T
Be sure to refer to Chapter 5 "Adjustment"
R E Q U I R E D
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Sensor Test
Revision F
Tube
(see p184) and perform
172
Confidential