Epson Stylus Pro GS6000
5.8.2 CR Durability Test
This test should be performed after replacing the LOWER BEARING to confirm the
LOWER BEARING is securely installed.
Procedure
1.
Enter the Serviceman Mode.
Turn the printer ON while pressing [Pause/Reset] + [Paper Feed
[Menu] simultaneously.
2.
When
SELF TESTING
is displayed, press the [Enter] button.
3.
Select
Life
=>
CR
Motor.
4.
Select
Speed CW
=> 400CPS, and press the [Enter] button.
5.
Select
Speed CCW
=> 400CPS, and press the [Enter] button.
6.
Select
Paper Size
=> 1850mm, and press the [Enter] button.
7.
Select
Head Fan
=> ON, and press the [Enter] button.
8.
Press
or
button until 10 is displayed.
9.
Press the ENTER button.The carriage starts moving.
C H E C K
Check if there is any abnormal noise or abnormality when the
P O I N T
carriage moves.
10. The carriage stops after ten back-and-forth cycles. Turn the power off if no
abnormal noise or abnormality is observed.
ADJUSTMENT
] +
Tests
Revision F
235
Confidential