Epson Stylus Pro GS6000 Service Manual page 107

Epson Stylus Pro GS6000
When routing the cable, make sure to give it one turn around the
marked clamp. See Figure 4-53.
7. Remove the two screws and remove the fixing plate.
B) Silver, Phillips, Pan with S.W & P.W M3x30: two pieces
Fixing plate
Figure 4-54. Removing the fixing plate
A D J U S T M E N T Be sure to refer to Chapter 5 "Adjustment"
R E Q U I R E D
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Fan Test
DISASSEMBLY & ASSEMBLY
HEATER BOARD
COOLING FAN
B
(see p184) and perform
Disassembly and Assembly Procedure
4.4.5.5 COOLING FAN PE
1. Remove the five screws and open the Elec Box.
A) Silver, Phillips, Pan with S.W & P.W M4x8: five pieces
2. Disconnect the relay connector, and release the harness from the two clamps.
3. Remove the two screws that secure the fixing plate to the main unit.
A) Silver, Phillips, Pan with S.W & P.W M4x6: two pieces
Clamps
Screws A
Figure 4-55. Removing the COOLING FAN PE from the main unit
Revision F
See Figure 4-40.
Relay connector
Fixing plate
107
Confidential