Epson Stylus Pro GS6000 Service Manual page 90

Epson Stylus Pro GS6000
4.4.3.5 IH COVER
C H E C K Basically you can remove this part on the left and the one on
P O I N T
the right in the same way. Therefore this section describes the
way to remove the one on the right only.
When removing the covers on the left, remove the MAINTE
COVER T (p88) in Step 2.
1. Remove the TOP COVER. (p85)
2. Remove the PANEL COVER, T.
3. Remove the SIDE COVER. (p89)
4. Open the Ink Cover (not an ASP).
As seen from the rear
Push here
Figure 4-23. Opening the Ink Cover
DISASSEMBLY & ASSEMBLY
(p86)
Ink Cover
IH COVER
Disassembly and Assembly Procedure
5. Remove the three screws from outside.
A) Silver, Phillips, Pan with S.W & P.W M4x8: three pieces
As seen from the outside
Figure 4-24. Removing the IH COVER (outside)
Revision F
IH COVER
A
90
Confidential