Epson Stylus Pro GS6000 Service Manual page 36

Epson Stylus Pro GS6000
Ctrl.Test
Test
Error History
Edge Sns Lvl
CR Origin Adjust
Platen Adjust
Heater Temp
Adjustment
Rear AD
Init.Fill
Nozzle Check
PRODUCT DESCRIPTION
Menu
Tank Valve
Ctrl.Actuator
Ink Valve
Ink Pump
Wiper
Error0
Error1
Error2
Error3
Error4
Error5
Pre Heater Temp
Platen Heater Temp
After Heater Temp
Output Pattern
Table 1-1. Menu List
Valve1 On
Valve2 On
Valve3 On
Valve4 On
Operates the solenoids of the sub tank valves.
Valve5 On
Valve6 On
Valve7 On
Valve8 On
Valve1 On
Valve2 On
Operates the solenoids of the ink valves.
Valve3 On
Valve4 On
Rotates the pump motors.
Operates the wiper (head cleaner).
Displays the error history in reverse chronological order.
Adjusts the media side detection sensor.
Adjusts the CR HP sensor position.
Used in the factory to warm the platen in a way to do a precise horizontal adjustment.
Sets the temperature of the heaters.
(The settings are cancelled when exiting the Serviceman Mode)
Adjusts AD value of the paper rear sensor.
Executes the initial ink charge.
Prints the nozzle check pattern.
Control Panel
Revision F
Explanation
Confidential
36