Banding Reduction System (Brs) Adjustment / Paper Feed Amount Profile (Pfp) Correction; Overview - Epson Stylus Photo R280 Service Manual

Color inkjet printer
Hide thumbs Also See for Stylus Photo R280:
Table of Contents

Advertisement

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50
5.3 Banding Reduction System (BRS) Adjustment /
Paper Feed Amount Profile (PFP) Correction

5.3.1 Overview

This section explains how to carry out BRS/PFP adjustments.
C H E C K
For overview of BRS/PFP Adjustment, refer to Chapter 2
P O I N T
Banding Reduction System (BRS) / Paper Feed Amount Profile
Correction (PFP) (p.25)
Be sure to have a specified scanner ready beforehand as it is
necessary to carry out the adjustment. Before scanning,
confirm that the document table is free from any dirt or stain.
Tools and paper required to perform the adjustment
Table 5-6. Tools and Paper for BRS/PFP Adjustment
Tools/Paper
Common
PFP Base scale
Matte Paper-Heavyweight
BRS
Premium Glossy Photo Paper
PFP
Specified Scanner to perform the adjustment
Install the driver of the scanner to the PC in advance.
C A U T I O N
As the profile required for the adjustment is not prepared for
scanners other than the ones specified below, BRS/PFP
Adjustment can not be carried out by the other scanners.
Chapter 5 Adjustment

5.3 Banding Reduction System (BRS) Adjustment / Paper Feed Amount Profile (PFP) Correction

Product Code
1453980
---
(A4)
---
(4 x 6)
The following are the scanners that can be used for scanning the pattern in BRS/PFP
adjustment. When starting up the adjustment program, select the scanner to use.
Table 5-7. Specified Scanner for BRS/PFP Adjustment
Model Name
Epson Perfection 4990 Photo
Epson Perfection V700 Photo
"2.2
Epson Stylus Photo RX560/RX580/RX590
Epson Stylus Photo RX585/RX595/RX610
Epson Stylus Photo RX680/RX685/RX690
Artisan 800/Epson Stylus Photo PX800FW/TX800FW
Artisan 700/Epson Stylus Photo PX700W/TX700W
C H E C K
Depending on the sensor type of the scanner to use for the
P O I N T
adjustment, drying time required after the BRS adjustment
pattern has been printed differs. For PFP adjustment pattern/PFP
check pattern, drying time is not required.
For "CCD" sensor:
Printed pattern can be scanned straight away. (Drying time of
about 2 minutes is recommended.)
For "CIS" sensor:
Printed pattern needs to be dried more than 5 minutes.
Test Pattern
Scanner
Sensor type
CCD
CCD
CIS
CIS
CIS
CIS
CIS
PC
Figure 5-11. System Configuration
Revision C
Remarks
Use the internal scanner.
Use the internal scanner.
Use the internal scanner.
Use the internal scanner.
Use the internal scanner.
Calculate
correction
value
Printer
115
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents