Fans - Epson Stylus Pro GS6000 Service Manual

Epson Stylus Pro GS6000

4.4.5 Fans

4.4.5.1 COOLING FAN (24V)
1. Remove the TOP COVER (both).
2. Remove the REAR COVER. (p95)
3. Remove the FRONT CLEAR COVER.
4. Remove the ten screws from the Mid Top Cover (not an ASP).
A) Silver, Phillips, Pan with S.W & P.W M3x8: ten pieces
In the next step, take care not apply excessive force to the hinges on
C A U T I O N
both sides of the Front Clear Cover. It may cause misalignment of
the hinges' phase.
5. Avoiding the hinges, remove the cover.
As seen from the front
As seen from the rear
Figure 4-44. Removing the Mid Top Cover
DISASSEMBLY & ASSEMBLY
(p85)
(p94)
Mid Top Cover
Mid Top Cover
Disassembly and Assembly Procedure
6. Disconnect the relay connector and release the cable.
When routing the cable, make sure to give it one turn around the
cable clamp as shown in figure below.
7. Remove the two screws and remove the COOLING FAN (24V).
A) Silver, Phillips, Pan with S.W & P.W M3x30: two pieces
As seen from the left
Figure 4-45. Removing the COOLING FAN (24V)
A
Revision F
Inside the Mid Top Cover
COOLING
FAN (24V)
Relay
connector
Clamp to turn
Confidential
A
101