Cautions And Preparation For Pattern Printing - Epson Stylus Pro GS6000 Service Manual

Epson Stylus Pro GS6000

5.1.6 Cautions and Preparation for Pattern Printing

Some adjustments require pattern printing. In those cases, follow the procedure below
to print correct patterns.
1. If a Media is set, remove it.
2. Turn OFF the printer.
3. Enter the Serviceman Mode.
Turn the printer ON while pressing [Pause/Reset] + [Paper Feed
simultaneously.
4. Select Adjustment => Heater Temp, and adjust each heater temperature to the
following values.
o
Pre Heater: 47 C
o
Platen Heater: 42 C
o
After Heater: 40 C
NOTE: Your printer temperature setup will be cancelled if you exit the
Serviceman Mode.
5. Wait until the heaters reach the good temperature.
Warming: "High Heat" LED Flashing
Ready: "High Heat" LED and "Low Heat" LED both bright.
6. Set the Adjustment Media. (After Service Tool)
Never touch the media's shiny face with bare hands: the oil of your
C A U T I O N
fingers on the paper will influence the print quality (fingerprints
will be visible)! You must use gloves to manipulate the media.
C H E C K
If you set the media when the heaters are cold, the temperature
P O I N T
change will cause the media to cockle, so always wait until the
temperature is reached before setting the media.
ADJUSTMENT
7. When lowering the pressure lever, the printer will check the media edges. Wait
until the recognition is finished before launching a print.
8. Print a pattern following the instructions for each procedure.
Pattern printing does not start until the temperature of each heater
C A U T I O N
rises up to their set values. If the printing does not start
immediately after executing the start command, wait a moment for
the heater temperature to rise.
] + [Menu]
C H E C K
P O I N T
For a pattern printed with the serviceman mode, when the print is
C A U T I O N
finished, the media is fed in a way that the pattern can be
completely visible and not hidden under the front clear cover.
When the next print is launched, the paper is back-fed so that the
next pattern is printed just above the previous pattern, hence
preventing paper waste. For this reason, the below points should be
heeded:
Overview
It is advisable to confirm no nozzles are missing with a Nozzle
Check Pattern and do a cleaning if required before printing
another pattern.
The printer will not print in the below conditions:
•
The preset heater temperature is not reached yet.
•
The front cover is open.
•
The media edges are not recognized yet.
Never use the Take-up Reel when printing with the Serviceman
Mode, for the Take-up reel cannot go backwards!!!
Never cut a media above the top edge of a pattern if you wish to
continue printing again a pattern from the serviceman mode:
the paper will back-feed to print just above the previous print
position and if the paper is cut too high, the printer might print
on the platen!!!
Revision F
197
Confidential