Epson Stylus Pro GS6000 Service Manual page 161

Epson Stylus Pro GS6000
When installing the spring between the PRINT HEAD and the
frame (See Figure 4-133), follow the procedure below using the
Spring Holder Jig. (the right one only)
1. Attach the spring to the tip of the Spring Holder Jig.
As seen from the front
2. Put the jig in place.
3. Screw the PRINT HEAD together with the jig (and the spring).
4. Pull up the jig to remove it.
As seen from the front
Spring Holder Jig
Put the jig here and screw together
DISASSEMBLY & ASSEMBLY
Spring Holder Jig
Spring
(See Figure 4-133 and the figure below.)
PRINT HEAD
(right)
Disassembly and Assembly Procedure
Fit the new head on the Head Base, in the Head holder jig in order
to fit the new VALVE ASSYs and the HEAD COVER in the new
head. (Previous Head Base and HEAD COVER can be re-used but
not the valve assys.)
At this point it is useful to write down the head ID as it has to be
registered during the adjustment. (See
Alignment Adjustments).
A D J U S T M E N T Be sure to refer to Chapter 5 "Adjustment"
R E Q U I R E D
specified adjustments after replacing or removing this part.
<Adjustment items>
1. Initial Ink Flag
2. Head Rank ID Input
3. Head Counter Reset
4. Nozzle Check Pattern
5. Cleaning and Washing
6. Head Slant and Alignment Adjustment
7. Head Nozzle Alignment Adjustment
8. Head Uni-D/Bi-D Low Gap Adjustment
Revision F
p212 for the Head
(see p184) and perform
161
Confidential