Rear Sensor Test/Rear Ad Adjustment - Epson Stylus Pro GS6000 Service Manual

Epson Stylus Pro GS6000

5.6.6 Rear Sensor Test/Rear AD Adjustment

5.6.6.1 Rear Sensor Test
This test allows you to test the Paper Rear Sensor.
Procedure
1. Select Sensor => RearAD.
2. Place some paper into the Paper Rear Sensor position (on the middle of the
Pre-heater).
C H E C K
Check that the value displayed on the panel changes according to
P O I N T
the paper existence.
Paper Rear Sensor
Figure 5-47. Paper Rear Sensor Position
ADJUSTMENT
5.6.6.2 Rear AD Adjustment
This function allows you to calibrate the Paper Rear Sensor in the following way.
Procedure
1. Select Adjustment
2. Place some paper into the Paper Rear Sensor position (on the middle of the
Pre-heater).
3. Press the [Enter] button to calibrate the sensor.
NOTE: Some Media may have marks on the reverse side. In such cases, make
sure not to put a dark mark above the sensor or the sensor will not be
able to detect the media.
Other Adjustments
=> RearAD.
Figure 5-48. Rear AD Adjustment
Revision F
230
Confidential