Epson Stylus Pro GS6000 Service Manual page 153

Epson Stylus Pro GS6000
When removing the LOWER BEARING, make sure to remove
C A U T I O N
it while supporting it at the bottom. Otherwise; if removed with
the spring extended, it might be damaged.
When removing the spring, be careful not to let it pop.
9. Slide the LOWER BEARING in the direction of the arrow, and remove the pin of
it from the main body.
10. Move the spring below and remove it from the cursor.
Cursor
Spring
Figure 4-123. Removing the Cursor
11. Remove the Spring from the LOWER BEARING.
Spring
Figure 4-124. Removing the Spring
DISASSEMBLY & ASSEMBLY
LOWER BEARING
LOWER BEARING
Disassembly and Assembly Procedure
1. Attach the spring removed from the LOWER BEARING.
2. Hold the cursor at the top so as not to let it move, attach the
LOWER BEARING to the cross-shaped rib on the cursor.
3. Insert the left dowel of the LOWER BEARING into the hole on
the cursor to the full.
Revision F
Cursor
LOWER BEARING
LOWER BEARING
Cursor
Hole
153
Confidential