Panel Settings - Epson Stylus Pro GS6000 Service Manual

EPSON Stylus Pro GS6000

1.4.2 Panel Settings

This section describes the panel settings that customers can change.
For the map of menu, see ?7.2 Panel Menu Map? (p259)
MENU LIST
Menu Item
SIDE MARGIN
PAPER SIZE CHECK
PAPER SKEW CHECK
PRINT NOZZLE PATTERN
PRINTER SETUP
HEATING TIME
FLUSH ONTO PAPER
FLUSING FREQUENCY
PAPER ORIGIN SETUP
PRODUCT DESCRIPTION
.
Parameter
(*: Default setting)
5mm* - 25mm
You can set the margin for left and right side.
(0.2inch* - 1.00inch)
ON* You can select whether to check the paper width.
ON:
Check the paper width and top edge of the paper.
NO:
OFF
Do not check the paper width and top edge of the paper. The printer continues to print even if the paper width
does not match the data width, and the printer may print beyond the paper. Because this soils the inside of the
printer, we recommend you select ON. This may result in a wider blank margin at the top of each page.
ON* If the paper is not straight, "PAPER SKEW" appears on the LCD panel and the printer stops printing.
A paper align error does not occur even if the printed data is out of range of the paper, and the printer continues
OFF
to print.
OFF*
When you select ON, the printer prints the nozzle check pattern before printing each print job or the 10th sheet,
ON: EVERY PAGE
depending on the setting you have set.
ON: EVERY 10 PAGES
OFF
You can set the length of time to preheat the heaters. When more than the set time has passed after turning on
the printer or after printing is finished, each heater turns off.
10min* - 240min
YES* You can set up the flushing operation while printing.
YES:
The printer performs the flushing operation on the page margins. The printing speed improves since the
number of times to return to the flushing box is decreased.
NO
NO:
Performs the flushing operation to return to the flushing box every time the print head goes and returns.
5PASS* You can set the frequency that the print head returns to the flushing box when setting YES in the FLUSH ONTO
PAPER setting. (When you select 5PASS, the print head returns to the flushing box every time the print head
1PASS - 999PASS
goes and returns five times.)
0mm* - 800mm You can set the beginning of printing (origin) of the horizontal direction.
Control Panel
Explanation
Revision F
24
Confidential